SPECIFICATION COMPLIANCE
DUBOARD is tested to ASTM and other relevant international standards.
QUALITY ASSURANCE
Duproof is ISO 9001 Quality Assured Company and all DUBOARD carry a 10– year material warranty against any manufacturing defects.
USES AND COMPATIBILITY
Protection to waterproofing membranes and coatings in foundations, Floors, terraces, bridge decks, planters, etc. DUBOARD provides positive protection not only during construction activities and backfilling, but also at the time of later settlement.
DUBOARD is compatible with a wide range of waterproofing systems, including: All cold applied and hot applied bituminous sheet membranes and liquid applied systems.
INSTALLATION
Install DUBOARD continuously over the membrane, butting the joints. Cut DUBOARD sheets with a roofer’s knife as required obtaining complete coverage and a neat overall finish. For maximum protection all butt joints may be taped with a 50 mm wide PVC Tape. On vertical areas spot bond the boards with a compatible bituminous or neoprene adhesive, using temporary supports in place until backfilling operation. In horizontal areas spot bonding at corners and sides of the boards will be sufficient to avoid slippage during subsequent work over the boards.
Torching: In certain cases the boards can be lightly torched applied to the membrane for permanent fix Consult Duproof or your local distributor for advice.
Backfilling: Concrete or application of toppings over the boards must begin as early as possible, after installation of DUBOARD. Backfilling must be carried out with care to avoid dragging the boards down.
PACKING & STORAGE
DUBOARD boards are stacked on a pallet one over the other and stretch wrapped. Store on level ground and under shade.
HEALTH & SAFETY
There are no health hazards associated with the normal usage. Wear gloves while handling to avoid injury; refer to the MSDS sheets for advice.
GENERAL DATA
Thickness | [mm] | 6.0 |
Nominal weight (approximately) | [Kg / m2] | 6.5 |
Dimensions (length / width) | [m] | 2 / 1 |
Coating | Polymer modified bitumen |
TECHNICAL DATA
PROPERTY | UNIT | TEST METHOD | VALUE |
---|---|---|---|
Softening Point | [o C] | ASTM D 36 | 150 |
Bitumen Content (By Weight) | % | – | =>60 |
Heat Resistance, 2 hrs. @120oC | UEAtc | No Flow | |
Flexibility at 25oC | UEAtc | Flexible | |
Puncture Resistance | N | ASTM E 154 | >1200 |
Water Absorption | % | ASTM D 570 | < 0.4 |
Note: Tolerances on nominal values shown are as per UEAtc directives for polymer modified bitumen membranes. These data are correct at the time of printing but may be changed without prior notice subject to client`s requirements, availability of raw materials or other conditions. This data sheet supersedes all the previous publications pertaining to this product. All reasonable care has been taken in preparing this document, which to the best of our knowledge is accurate and true. Recommendations and suggestions are made in good faith and should only be considered for general guidance. No liability is assumed or taken by us in relation to the application, as usage conditions and any labor involved are beyond our control.